METHODOLOGY FOR MODELING HIGH PERFORMANCE CONCRETE PROPERTIES

Authors

  • Carlos Videla
  • Cristián Gaedicke Pontificia Universidad Católica de Chile

Keywords:

high performance concrete, BFS Cement, compressive strength, flexural strength, elastic modulus, abrasion resistance, autogenous shrinkage, drying shrinkage

Abstract

In this research, the most important properties of HPC were analyzed. The study was focused on HPC with specified 28 days compressive cylindrical strengths between 60 to 110 MPa and made with locally available materials: Rapid Hardening Portland Blast Furnace Slag Cement, siliceous aggregates and commercial admixtures. Compressive and flexural strength, elastic modulus, abrassion resistance and shrinkage properties were analyzed and modeled using innovative methods. Laboratory test results showed that it is possible to develop a general model for compressive strength combining a hyperbolic equation for strength evolution and an exponential equation for mix design parameters. It was also concluded that the measured moduli of elasticity are lower than the predicted values by ACI 363 and ACI 318 equations, and that the square root of the compressive strength did not turn out to be a good predictor of the flexural strength, for the used materials. Furthermore, it was concluded that the ASTM C944-99 abrassion test is not very effective to measure abrassion resistance of HPC, due to the high variability of results. Strain measurements showed that autogenous shrinkage is a significant part of the total shrinkage. It was shown that the FIB 2000 model is adequate to predict shrinkage of HPC, but some coefficients must be updated to local conditions. An updating method for shrinkage models was successfully applied.

Downloads

Download data is not yet available.

Author Biographies

Carlos Videla

Professor, Department of Construction Engineering and Management. Pontificia Universidad Católica de Chile Project Manager, Quality and Inspection Services CIT - DICTUC S.A. Manager, Strength of Materials Area, DICTUC S.A. Santiago, Chile

Cristián Gaedicke, Pontificia Universidad Católica de Chile

MSc Student in Engineering Sciences, Departamento de Ingeniería y Gestión de la Construcción.

Published

2003-08-30

How to Cite

Videla, C., & Gaedicke, C. (2003). METHODOLOGY FOR MODELING HIGH PERFORMANCE CONCRETE PROPERTIES. Revista Ingeniería De Construcción, 18(2), 64–77. Retrieved from https://revistaingenieriaconstruccion.uc.cl/index.php/ric/article/view/18055

Issue

Section

Original Research

Most read articles by the same author(s)

1 2 > >>